Handlebar Push Button PB-1

Handlebar mounted button for electronic relays and button controls
Color 
Size 
39,95 €
incl. 19% VAT , plus shipping costs
  • Available immediately
Description

The handlebar switch PB-1 is electric motorcycle accessory. It is available for metric handlebars with a diameter of 22.23 mm and for imperial handlebars with a diameter of 1 inch / 25.40 mm. It has a load capacity of 50mA and is therefore suitable to provide a control signal of max. 50mA. The handlebar switch PB-1 is the ideal complement to our electronic load relay SER-100 but can also be used in combination with other electronic relays or button control units.

CAUTION: Do not use the button to switch a load such as an auxiliary light or a horn directly. Not suitable for use on off-road vehicles or when exposed to heavy dirt. Use only on motorcycles, trikes, quads etc. with 12V electrical system. Disregard of these instructions will cause loss of warranty.

Technical Data

Operating voltage 3 – 32V DC
Load capacity max. 50mA
Principle of operation single pole normally open, momentary contact, off (on)
Operating temperature -40°C – 85°C
Measurements 15 x 12 mm (D x H)
Connection wires 600 mm / 23,6 inches each
Water / dust protection partially encapsulated, IP67

Material

Aluminium, natural or black anodized

Scope of Supply

  • 1 handlebar switch PB-1 with 600 mm leads
  • 1 black zip tie 3.6 x 150 mm
  • 1 black heat shrink tubing 3.2 x 550 mm

Manual /Betriebsanleitung

Write the first review for this item and help others make a purchase decision!

There are no reviews yet.